Test results will be written into 'releases/testresults/2024.02.1-2024-04-28-cb578cd3' Event bootloader 9.483/20: 00 ┌──────────────────────────────────────────────────────────┐ 01 │ i586con, the tiny RAM-based linux │ 02 ├──────────────────────────────────────────────────────────┤ 03 │ Linux to RAM, textmode │ 04 │ Linux to RAM, VESA at 1024x768-16 │ 05 │ Run from CD, textmode │ 06 │ Run from CD, VESA at 1024x768-16 │ 07 │ BIOS to RAM, textmode │ 08 │ BIOS to RAM, VESA at 1024x768-16 │ 09 │ GRUB2 (Memdisk floppy image) │ 10 │ Poweroff │ 11 │ List VESA Graphics Modes │ 12 │ Memtest86+ │ 13 │ │ 14 │ │ 15 └──────────────────────────────────────────────────────────┘ 16 17 Press [Tab] to edit options 18 19 Automatic boot in 5 seconds... 20 21 22 23 24 login prompt Timeout 200: 00 [ 17.536435] usb-storage 1-1:1.0: USB Mass Storage device detected 01 [ 17.556357] scsi host2: usb-storage 1-1:1.0 02 [ 18.626237] scsi 2:0:0:0: Direct-Access QEMU QEMU HARDDISK 2.5+ PQ 03 : 0 ANSI: 5 04 [ 18.697143] sd 2:0:0:0: [sda] 90112 512-byte logical blocks: (46.1 MB/44.0 Mi 05 B) 06 [ 18.730117] sd 2:0:0:0: [sda] Write Protect is off 07 [ 18.748069] sd 2:0:0:0: [sda] Write cache: enabled, read cache: enabled, does 08 n't support DPO or FUA 09 [ 18.909070] sda: sda1 10 [ 18.997203] sd 2:0:0:0: [sda] Attached SCSI disk 11 Media found and mounted. 12 Unpacking save.tgz... 13 Setting up overlay... 14 [ 20.801850] loop0: detected capacity change from 0 to 73099 15 [ 20.808934] loop0: detected capacity change from 73099 to 73098 16 Switching to main /sbin/init 17 Saving 256 bits of creditable seed for next boot 18 Starting syslogd: OK 19 Starting klogd: OK 20 Launching net_daemon.sh 21 Populating /dev using udev: done 22 Starting network: OK 23 Starting gpm (eventually, maybe) 24 === SUMMARY for 01-lowram-usb === total time | wait time | event 9.5s | 9.5s | bootloader 210.6s | | login prompt - timeout === HTML: 01-lowram-usb.html